A lot of information can be read from a TDR screenshot. Below is TDR readout of a PCB with a connector at the end:

Using the histogram function (red histogram on the left side of the picture) impedance is measured automatically. On the bottom (red ellipse) the measurement result of 57.5Ohm with the corresponding statistical variation is shown.

The TDR measurement starts with the 50Ohm cable used to supply the step to the DUT (first green ellipse).

After that, a capacitive dip can be seen (first blue circle). If a connector is used to supply the step to the DUT this would  be the connector. In this particular case a proper RF probe was used avoiding this kind of capacitive load. Here, it is really the pad at the edge of the PCB which causes a capacitive dip. One possible counter measure would be to reduce the size of the ground plane underneath the edge pad.

Next, the 57Ohm transmission line on the PCB can be seen (second green elipse, target impedance was 60 Ohm). The length of around 680ps (left to right yellow bar) is twice the flight time of the signal (as we are measuring the reflection). So the electrical length is around 340ps. At a signal speed of 6ps/mm this calculates to around 56mm physical length.

Finally, there is a last huge capacitive dip. This is a SMD SO-DIMM connector with large pads causing high capacitive load. Integrating the area of the dips and peaks, the scope can accurately calculate the size of any capacitor or an inductor on the trace.